HP ProCurve 5400zl Reference Manual page 297

Command Line Interface Reference Guide
o infinite - sets the timeout to 0. A value of 0 indicates an infinite
timeout to the switch. (Internally the ARP age timeout is set to 99,999,999
seconds (approximately 3.2 years)
Next Available Options:
timeout
■
in minutes (NUMBER)
infinite -- Causes the ARP timeout to be set to 0, indicating an infinite timeout period.
■
Example 1. Example of ip arp-age Command
ProCurve(config)# ip arp-age 1000
authorized-managers
■ [no] ip authorized-managers
Usage: [no] ip authorized-managers <IPV4-ADDR> [IPV4-MASK]
Description: Define the IPV4 addresses allowed to manage the switch.
Parameters:
o IPV4-ADDR - The IPV4 address of an authorized manager.
o IPV4-MASK - A mask that allows you to define which portions of
the listed IP address need to be matched by an incoming request.
The default mask is 255.255.255.255. For example, with an
authorized address of 10.8.11.1 and a mask of 255.255.255.255,
only access from 10.8.11.1 is allowed. With a mask of
255.255.255.0, access from any IP address with 10.8.11.x is
allowed.
o access <manager|operator> - A designation of the management
capabilities that are accessible to the authorized manager.
'manager' allows full access to all web browser and telnet to console
for viewing and setting the switch configuration, and for performing
all other interface operations,including all TFTP operations.
'operator' allows view-only access from the web browser and the
console, but does not allow changing the switch configuration or any
TFTP operations. The default access level is manager.
o access-method <all|ssh|telnet|web|snmp|tftp> - A designation of the
access method that the authorized manager will allow for this rule.
The default access method is all.
Next Available Option:
IPV4-ADDR
■
© 2009 Hewlett-Packard Development Company, L.P.
< 1 to 1440 > -- Modify Address Resolution Protocol (ARP) table entry timeout, specified
(p. 311)
[access <manager|operator>]
[access-method <all|ssh|telnet|web|snmp|tftp>]
Clients using the specified IPV4 addresses are allowed
to access the switch with the specified access method and
access level.
A maximum of 100 addresses may be configured.
-- Authorized manager IPv4 address. (IP-ADDR) (p. 303)
ip
(p. 301)
295