HP ProCurve 5400zl Reference Manual page 257

Command Line Interface Reference Guide
Next Available Option:
port-name
■
■ interface vlan VLAN-ID name NAME
Usage: name ASCII-STR
Description: Set the VLAN's name.
■ interface svlan VLAN-ID name NAME
Usage: name ASCII-STR
Description: Set the VLAN's name.
nbr-timeout
■ interface vlan VLAN-ID ip pim-sparse nbr-timeout < 60 to 8000 >
Usage: ip pim-sparse nbr-timeout <60-8000>
Description: Set the neighbour loss time interval for this interface.
Range: < 60 to 8000 >
nd
■ [no] interface vlan VLAN-ID ipv6 nd
Usage: [no] ipv6 nd <parameter>
Description: IPv6 nodes on the same link use Neighbor Discovery to
<parameter> - Configure various Neighbors Discovery parameters.
Next Available Options:
ns-interval
■
sent for an unresolved destination, or between duplicate address detection neighbor solicitation
requests(p. 256)
reachable-time
■
confirmed as reachable via the neighbor unreachability detection
no-default
■ interface vlan VLAN-ID ip irdp preference no-default
© 2009 Hewlett-Packard Development Company, L.P.
-- Specify a port name up to 64 characters length. (ASCII-STR)
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
Default is 180 seconds.
discover each other's presence, link-layer addresses,
routers and to maintain reachability information about the
paths to active neighbors.
o ns-interval
o reachable-time
-- Configures the neighbor discovery time between neighbor solicitation requests
-- Configures the length of time neighbors are considered reachable after being
interface
(p. 263)
algorithm(p. 273)
255