OVERVIEW
Category:
Primary context:
Related Commands
Usage: [no] vlan VLAN-ID [...]
Description: Add, delete, edit VLAN configuration or enter a VLAN context.
COMMAND STRUCTURE
■ vlan VLAN-ID
using the GARP VLAN Registration Protocol (GVRP) ([ethernet] PORT-LIST)
■ vlan VLAN-ID
previously blocked by the connection rate filter
unblock
■
all
-- Resets all previously blocked by the connection rate filter
■
host
■
src-ip
■
■ [no] vlan VLAN-ID
■ [no] vlan VLAN-ID
PORT-LIST)
■ [no] vlan VLAN-ID
domain-name
■
with the VLAN. (ASCII-STR)
■ vlan VLAN-ID
access-group
■
713)
direction
■
address
■
dhcp-bootp
■
722)
ip-addr
■
bootp-gateway
■
requests
ip-addr
■
forward-protocol
■
© 2009 Hewlett-Packard Development Company, L.P.
VLANs
config
show vlans (page 607)
ip (page 290)
ipv6 (page 313)
router (page 471)
mirror-port (page 381)
If an existing VLAN-ID is specified you are put into the
context for that VLAN, and can then execute commands for that
VLAN. If a new VLAN-ID is specified, the new VLAN is added with
the VLAN-ID, and you are put into the context of the new VLAN.
If you follow the command with one of the VLAN Context commands
in the same command line, the context level is not changed, but
the commands are executed for the VLAN specified by the
VLAN-ID. The 'no' option of the VLAN command is used to delete
the VLAN specified by VLAN-ID.
auto
-- Cause each port identified in the port list to learn its VLAN membership
connection-rate-filter
-- Resets a host previously blocked by the connection rate filter
-- Match packets from the specified IP address. (IP-ADDR)
-- Match packets from the specified subnet. (IP-ADDR/mask-LENGTH)
dhcp-snooping
forbid
-- Prevent ports from becoming a member of the current VLAN ([ethernet]
(p. 724)
igmp-proxy
-- Associate an IGMP proxy domain with a VLAN
< END OF PRINTABLE > -- Specify the domain name to associate/disassociate
(p. 722)
ip
-- Configure various IP parameters for the VLAN
-- Apply the specified access control list on this VLAN interface (ASCII-STR)
< in | out | connection-rate-filter | ... > --
-- Set IP parameters for communication within an IP network
-- Configure the interface to use DHCP/Bootp server to acquire parameters.
-- Interface IP address/mask. (IP-ADDR/mask-LENGTH)
-- Add or remove the gateway address to be used for stamping incoming DHCP
(p. 720)
-- IPv4 address of the BOOTP gateway. (IP-ADDR)
-- Add or remove a UDP server address for the VLAN
-- Re-enables access to a host or set of hosts that has been
(p. 721)
--
(p. 722)
(p. 719)
(p. 749)
(p. 715)
(p. 727)
(p. 728)
(p. 722)
(p. 713)
(p. 729)
(p. 729)
(p. 724)
vlan
(p. 748)
(p. 727)
(p.
(p.
706