HP ProCurve 5400zl Reference Manual page 577

Command Line Interface Reference Guide
spf-log -- List the OSPF SPF(Shortes Path First Algorithm) run count for all OSPF areas and last
■
ten Reasons for running
statistics
■
enabled
area -- Show OSPF areas configured on the
■
external-link-state
■
the device is
interface
■
link-state
■
is attached(p. 565)
neighbor
■
redistribute
■
restrict -- List routes which will not be redistributed via
■
traps -- Show OSPF traps enabled on the
■
virtual-neighbor
■
virtual-link
■
output
■ show bandwidth output
Show outbound guaranteed minimum bandwidth.
Next Available Option:
port-list
■
PARAM-NAME
■ show snmpv3 params PARAM-NAME
Show a specific Target Parameter entry.
params
■ show snmpv3 params
Show SNMPv3 Target Parameters table.
Next Available Option:
PARAM-NAME
■
peer
■ show ip rip peer
Usage: show ip rip peer [IP-ADDR]
Description: Show RIP peers. Invoked without parameters shows all RIP
Next Available Option:
peer-ip -- Specify IP address of the RIP peer to show. (IP-ADDR)
■
© 2009 Hewlett-Packard Development Company, L.P.
SPF(p. 593)
-- List OSPF packet statistics( OSPF sent,recieved and error packet count) of all OSPF
interfaces(p. 594)
-- Show the Link State Advertisements from throughout the areas to which
attached(p. 550)
-- Show OSPF interfaces'
-- Show all Link State Advertisements from throughout the areas to which the device
-- Show all OSPF neighbors in the locality of of the
-- List protocols which are being redistributed into
-- Show all virtual neighbors of the
-- Show status of all OSPF virtual links
-- Specify ports for which information will be shown. ([ethernet] PORT-LIST)
-- Show a specific Target Parameter entry. (ASCII-STR)
peers of the device. If 'IP-ADDR' is specified only
the peer having the address is displayed.
device(p. 529)
information(p. 559)
OSPF(p. 586)
device(p. 599)
device(p. 603)
configured(p. 603)
device(p. 573)
OSPF(p. 584)
(p. 575)
(p. 576)
show
(p. 578)
575