HP ProCurve 5400zl Reference Manual page 238

Command Line Interface Reference Guide
Next Available Options:
join-timer
■
leave-timer
■
leaveall-timer
■
hello-delay
■ interface vlan VLAN-ID ip pim-dense hello-delay < 0 to 5 >
Usage: ip pim-dense hello-delay <0-5>
Description: Set the maximum time before a triggered PIM Hello message is
Range: < 0 to 5 >
■ interface vlan VLAN-ID ip pim-sparse hello-delay < 0 to 5 >
Usage: ip pim-sparse hello-delay <0-5>
Description: Set the maximum time before a triggered PIM Hello message is
Range: < 0 to 5 >
hello-interval
■ interface vlan VLAN-ID ip ospf hello-interval < 1 to 65535 >
Set hello interval in seconds; the default is 10.
Range: < 1 to 65535 >
■ interface vlan VLAN-ID ip ospf IP-ADDR hello-interval < 1 to 65535 >
Set hello interval in seconds; the default is 10.
Range: < 1 to 65535 >
■ interface vlan VLAN-ID ip ospf all hello-interval < 1 to 65535 >
Set hello interval in seconds; the default is 10.
Range: < 1 to 65535 >
■ interface vlan VLAN-ID ip pim-dense hello-interval < 5 to 300 >
Usage: ip pim-dense hello-interval <5-300>
Description: Set the frequency at which PIM Hello messages are transmitted
Range: < 5 to 300 >
■ interface vlan VLAN-ID ip pim-sparse hello-interval < 5 to 300 >
Usage: ip pim-sparse hello-interval <5-300>
Description: Set the frequency at which PIM Hello messages are transmitted
© 2009 Hewlett-Packard Development Company, L.P.
The timers must follow the constraints
2 * join-timer <=
< 20 to 75 > -- Set join timer value (centiseconds; default
< 40 to 300 > -- Set leave timer value (centiseconds; default
< 500 to 3000 > -- Set leaveall timer value (centiseconds; default
transmitted on this interface. Default value is 5 seconds.
transmitted on this interface. Default value is 5 seconds.
on this interface. Default value is 30 seconds.
on this interface. Default value is 30 seconds.
leave-timer < leaveall-timer
interface
20).(p. 246)
300).(p. 248)
1000).(p. 248)
236