Diagnostic Messages With Instructions For Fault Clearance - Festo CAMC-G-S3 Manual

5 Operation
5.6

Diagnostic messages with instructions for fault clearance

Error group 0 Information
No. Code Message
0-0 - Invalid error
Cause
Measure
0-1 - Invalid error detected and corrected
Cause
Measure
0-2 - Error cleared
Cause
Measure
0-4 Serial number / type of equipment (module replacement)
-
Cause
Action
0-7 - Subsequent entry
Cause
Action
0-8 - Controller switched on
Cause
Action
0-9 - Controller safety parameters revised
Cause
Action
0-10 - Safety module: Parameter revised
Cause
Action
0-11 - Module change: Previous module
Cause
Action
0-12 - Module change: Current module
Cause
Action
0-13 Safety module: Error acknowledged
-
Cause
Action
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English
Information: An invalid error entry (corrupted) was found in the
diagnostic memory marked with this error number.
The system time entry is set to 0.
–
Information: An invalid error entry (corrupted) was found in the
diagnostic memory and corrected. The additional information con­
tains the original error number.
The system time entry includes the address of the corrupted error
number.
–
Information: Active errors were acknowledged.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Reaction
Ignore
Ignore
Ignore
Ignore
Ignore
Ignore
Ignore
Ignore
Ignore
Ignore
Ignore
209