Selection Of The Session Variant In The Wizard - Festo CAMC-G-S3 Manual

4 Commissioning
4.6.1

Selection of the session variant in the Wizard

1. Start the SafetyTool with the "Start SafetyTool" button è Section 4.5.1.
2. In the Wizard for starting safe parameterisation, select the session type "Online ..." and confirm this
with "Next".
3. Select the session variant "Change existing parameterisation" and confirm this with "Next".
After this, a note on the session variant is displayed which you should read and then confirm with
"Next".
4. To write parameters, it is necessary to enter a user ID and the password. In the delivery status or
after a reset to the factory setting, this is "SAFETY".
180 Festo – GDCP-CAMC-G-S3-EN – 1406NH – English