Festo CAMC-G-S3 Manual page 308

C Glossary
Term
Safe parameter set
Safety module
SafetyTool project
SCV
SFR
SSR
Validation code
Tab. C.2 Terms for the SafetyTool and for safe parameterisation
308
Meaning/function
The sum of all the parameters of the safety module forms a parameter set. If
this parameter set contains a valid validation code, then it is a "safe paramet­
er set".
The safe parameter set of an application is thus always located in a safety
module ready for operation. In addition, it can be read out with the
SafetyTool and stored, including the validation code generated by the safety
module. On the storage medium, it is protected against changes with a
checksum.
CAMC-G-S3 as a plug-in module in the basic device, which is responsible for
the safety of the drive application. The parameterisation of this safety mod­
ule takes place with the SafetyTool.
The SafetyTool allows the user to save the locally-available parameterisation
as a "SafetyTool project". This file contains the parameters as a display value
(in contrast to the safe parameter set to which device values are saved).
The SafetyTool project can be sent to the safety module in an online session.
The user must validate the sent parameters individually.
Safety Condition Violated.
Safety Function Requested.
Safe State Reached.
Content of a special communication generated by the safety module, when
all the parameters have been validated.
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English