A.5.3 Start Trace - Festo CAMC-G-S3 Manual

A Technical appendix
A.5.3 Start trace
Normally, the settings of the "Configure trace data" page are sent to the motor controller automatically
when the trace is started. This is not possible, if a CAMC-G-S3 safety module is installed, as the trace
data determined by the safety module only takes effect after a restart.
For this reason, the FCT PlugIn displays the following dialog box as soon as one or more items of data
contained in è Tab. A.42 are selected (with the exception of data from the basic unit).
Fig. A.10 Storing data and restarting
This is required once only after opening the CMMP-AS PlugIn in the FCT or after each change to the
trace data.
After restart of the motor controller, you can start the trace normally.
A.5.4 Example
Any violation of the safety condition on SS1 should be recorded. DOUT42 is requested as a trigger by
VOUT_SCV "Safety Condition Violated".
Fig. A.11 Example: Configuring trace data
284 Festo – GDCP-CAMC-G-S3-EN – 1406NH – English