Festo CAMC-G-S3 Manual page 206

5 Operation
Safety function
USF0 (with SSF0: SLS, SSR, SSM)
USF1 (with SSF1: SLS, SSR, SSM)
USF2 (with SSF2: SLS, SSR, SSM)
USF3 (with SSF3: SLS, SSR, SSM)
SBC
Tab. 5.2 Display of the safety functions
Other displays
The following table shows other displays connected with the safety module.
Function/status
Active parameterisation session
The string is displayed at regular in­
tervals for as long as a parameterisa­
tion session occurs.
Identify controller
The string HELLO followed by the
1)
serial number of the basic unis is
displayed at regular intervals for as
long as the "Identification" function
is active (wave function).
1) The serial number of the basic unit is displayed in the FCT PlugIn on the "Controller" page and in the SafetyTool. In addition, you
can find the serial number on a little sticker on the underside of the device (between [X6] and [X2A]).
Tab. 5.3 Other displays
206
Display
U S F 0
U S F 1
U S F 2
U S F 3
S b C
Display
F S P A r A
H E L L O ...
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English