Festo CAMC-G-S3 Manual page 222

5 Operation
Error group 58 Error during communication / parameterisation
No. Code Message
58-0 80E9h Plausibility check of parameters
Cause
Action
58-1 General error, parameterisation
-
Cause
Action
58-4 80E9h Buffer, internal communication
Cause
Action
58-5 80EAh Communication module - basic unit
Cause
Action
222
The plausibility check in the safety module produced errors, e.g. an
invalid angle encoder configuration; the error is triggered when a
validation code is requested by the SafetyTool and when paramet­
ers are backed up in the safety module.
• Note instructions for SafetyTool for complete validation; critic­
ally check parameterisation.
Parameter session active for > 8 hrs.
The safety module has thus terminated the parameterisation session
The error message is saved in the diagnostic memory.
• Terminate parameterisation session within 8 hrs. If necessary,
start a new parameterisation session and continue.
– Communication connection faulty.
– Timeout / data error / incorrect sequence (packet counter) in
data transmission between the basic unit and safety module.
– Too much data traffic, new requests are being sent to safety
module before old ones have been responded to.
• Check communication interfaces, wiring, screening, etc.
• Check whether other devices have read access to the motor
controller and safety module during a parameterisation ses­
sion - this may overload the communication connection.
• Check whether the firmware versions of the safety module and
basic unit and the versions of the FCT PlugIn and SafetyTool are
compatible.
– Packet counter error during transmission μC1 <-è μC2.
– Checksum error during transmission μC1 <-è μC2.
• Internal malfunction in the motor controller.
• Check whether the firmware versions of the safety module and
basic unit and the versions of the FCT PlugIn and SafetyTool are
compatible.
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English
Reaction
configurable
configurable
Fixed [8]
Fixed [8]