Festo CAMC-G-S3 Manual page 210

5 Operation
Error group 0 Information
No. Code Message
0-14 - Safety function requested
Cause
Action
0-15 Safety module: Parameterisation session started
-
Cause
Action
0-16 Safety module: Parameterisation session closed
-
Cause
Action
0-17 - Safety module: Password revised
Cause
Action
0-18 - Safety module: Password reset
Cause
Action
0-19 - Safety module: Parameter record loaded
Cause
Action
0-20 - Safety module: Parameter record saved
Cause
Action
0-21 - Log entry from the safety module
Cause
Action
Error group 51 Safety module/function
No. Code Message
51-0 8091h No / unknown safety module or driver supply faulty
Cause
Action
Cause
Action
210
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Information: è Diagnostic memory entry.
–
Internal voltage error of the safety module or microswitch module.
• Module presumably defective. If possible, replace with another
module.
No safety module detected or unknown module type.
• Install safety or microswitch module appropriate for the firm­
ware and hardware.
• Load firmware appropriate for the safety or microswitch mod­
ule, see type designation on the module.
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English
Reaction
Ignore
Ignore
Ignore
Ignore
Ignore
Ignore
Ignore
Ignore
Reaction
PSoff