Offline Parameterisation - Festo CAMC-G-S3 Manual

4 Commissioning
4.5.4

Offline parameterisation

You can do this completely offline in preparation for parameterisation.
However, to commission the safety module correctly, you must validate the parameters online and
transfer the validated parameters to the safety module.
1
Offline session
2
New paramete­
3
risation
4
5
1
Start the Wizard in Offline mode
2
Selection of the offline session variant
3
Information page on the appropriate session
variant
Fig. 4.4 Steps for the selection of the offline session variant
174
Start offline
session
Selection during
offline session
New project
Open project
from safe
parameter set
Select project Select safe
file parameter set
Exit wizard
4
5
Selection of a project file / a parameter set
Exit Wizard.
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English