Starting Parameterisation - Festo CAMC-G-S3 Manual

4 Commissioning
3. If all the parameters of the basic information are identical, then the other parameters are loaded
from the safety module and the "Data transfer" page is shown with the comparison of the data
transmitted from the basic unit.
4.6.3

Starting parameterisation

Now, the session variant "Change existing parameterisation" is active and you can begin the actual
parameterisation.
• To do this, use the arrow buttons 1 to navigate through all the parameter pages and check or
change the displayed parameters.
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English 183