Data Transfer And Synchronisation - Festo CAMC-G-S3 Manual

4 Commissioning
Exit the wizard with "Finish".
4.6.2

Data transfer and synchronisation

1. Normally, the basic information of the factory setting deviates from the current basic unit paramet­
erisation. This is shown in a dialog, which you should confirm with "OK".
If this is not the case, you can continue with item 3..
2. The deviating values are displayed in red on the Basic information page and must first be synchronised.
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English 181