A.5 Recording Trace Data - "Trace - Festo CAMC-G-S3 Manual

A Technical appendix
A.5 Recording trace data - "Trace"
A.5.1 Overview
For diagnostic purposes, you can also use the Trace function (oscilloscope function) of the FCT PlugIn
CMMP-AS to record the trace data of the safety module, in addition to the normal data of the motor
controller.
The recorded trace data is used for troubleshooting. It is not safety relevant.
The trace data and recording are parameterised via FCT (èSection A.5.2).
You can record up to four items of numeric or digital data in parallel. The following data is available for
the safety module:
Data
Numeric data
Upper limit, speed setpoint
1)
value
Lower limit, speed setpoint
1)
value
CAMC-G-S3: Actual speed
value
CAMC-G-S3: Actual position
value
CAMC-G-S3: Currently mon­
itored upper speed limit
CAMC-G-S3: Currently mon­
itored lower speed limit
Freely selectable CO ...
Digital Data
CAMC-G-S3: ...
CAMC-G-S3: DIN40A
...
CAMC-G-S3: DOUT40A
...
CAMC-G-S3: C1/C2
1) Data from basic unit
Tab. A.42 Trace data for the safety module
A.5.2 Configure
The recorded data is specified as usual in the FCT PlugIn CMMP-AS on the "Configure trace data" page.
For the safety module, the additional numerical and digital data contained in è Tab. A.42 is available.
282
Description
Current upper speed limit in the basic unit, limit set by the safety module.
Current lower speed limit in the basic unit, limit set by the safety module.
Actual rotational speed value from the safety module.
Actual position value from the safety module.
Current upper speed limit monitored by the safety module.
Current lower speed limit monitored by the safety module.
This selection can be used to record any number of parameters
è Section A.5.2.
Status bits of the safety module
Physical status of the input DIN40A
Physical statuses of the other inputs ...
Physical status of the output DOUT40A
Physical statuses of the other outputs ...
Physical status of the relay contact C1/C2
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English