Commissioning - Festo CAMC-G-S3 Manual

4

Commissioning

4 Commissioning
This chapter deals with the commissioning of the safety module. You can find information
on commissioning the motor controller here:
è Hardware description "Mounting and installation" GDCP-CMMP-M3-HW-...
è Help on the FCT plug-in CMMP-AS.
Please note
Commissioning in the sense of this document does not mean the first intended use by
the end customer, but commissioning by the machine manufacturer when setting up the
machine.
Please note
Failure of the safety function!
Missing safety functions can result in serious, irreversible injuries, e.g. due to uncon­
trolled movements of the connected actuator equipment.
• Operate the safety module only:
– if it is installed,
– after the safety module has been completely parameterised,
– when all safeguarding, including the safety function, has been installed and
checked for functionality.
• Validate the safety function to complete commissioning è Section 4.8.
Incorrect wiring, use of an incorrect safety module or external components that were not
selected according to the category will result in failure of the safety function.
• Carry out a risk analysis for your application and design the circuitry and components accordingly.
• Note the examples è Section 3.3.
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English 161