Festo CAMC-G-S3 Manual page 237
Safety module
Hide thumbs
Also See for CAMC-G-S3:
- Translation of the original instructions (24 pages) ,
- Instructions | safety function, advanced safety (4 pages) ,
- Translation of the original instructions (4 pages)
Table of Contents
Advertisement
A
Technical appendix
Please note
When the safety module is delivered, the SBC function is always configured in conjunc
tion with the output [X6], even if you do not wish to use the SBC function. In applica
tions in which the brake control lines are run in the motor cable, if no holding brake is
connected on the motor side, interference can be coupled into the open brake lines. The
safety module then generates the error 57-0.
• In these cases, please disconnect the brake control lines from X6 and route them to PE.
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English
237
Advertisement
Chapters
Table of Contents
