Online Parameterisation - Festo CAMC-G-S3 Manual

4 Commissioning
When you start the program, the SafetyTool supports you by displaying the "Configuration Wizard for
safe parameterisation". Select the desired session variant.
Session type Session variant
Online Start new parameterisation
è Section 4.5.3
Start new parameterisation
with existing project
Display parameterisation
Change existing parameterisa­
tion
Transfer safe parameter set
Offline Create a new project
è Section 4.5.4
Generate a new project from
safe parameter set
Open existing project1)
1) Only possible if the axis type (linear/rotating) of the SafetyTool project file agrees with the current FCT project.
Tab. 4.6 Selection of the session variants - Configuration wizard
4.5.3

Online parameterisation

If the online connection to the motor controller is active in the FCT PlugIn, then the functions for online
parameterisation are available in the SafetyTool.
Please ensure that the data in the motor controller agrees with the project data ("Down­
load") and has been backed up ("Backup") before starting the SafetyTool. Otherwise, the
basic information after the basic unit is restarted might differ from the basic information
that had been used.
The parameters and the parameter set can only be validated during online parameterisation.
For the online parameterisation functions, it is always necessary to state a user name and to enter a
password:
The factory setting for the password is: SAFETY
Assign an individual password to your project, in order to protect the safety parameters
from unintentional changes (Menu [Tools] [Change password] è Section 4.7.1).
When the SafetyTool starts, the SafetyTool compares its database with the data of the basic unit and
with that of the safety module. Depending on the selected session variant, an upload of the parameters
from the safety module is required for this.
172
Description
Opens a new project with the standard para­
meters from the safety module.
Opens a new project, based on a locally-saved
1)
project file.
Displays the parameterisation in the safety
module (read-only!).
Loads the parameterisation in the safety mod­
ule for editing.
Transfers a previously-saved safe parameter
set to the safe module.
Opens a new project with the standard set­
tings of the SafetyTool.
Opens a new project, based on a saved safe
parameter set.
Opens a locally-saved project file.
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English