Checking The Data Transfer - Festo CAMC-G-S3 Manual

4 Commissioning
The appropriate parameter page is displayed in the navigation tree 2, through which you can also
switch directly to another page, e.g. to subsequently review parameters.
For commissioning, we recommend checking or editing each page one after another.
4.6.4

Checking the data transfer

The most important parameters of the encoder configuration are displayed on the first parameter page
"Data transfer".
Any deviations are shown by a blue arrow. Clicking the arrow transfers the basic unit setting as the
parameter setpoint. The parameter setpoint must then be transferred to the safety function on the
appropriate encoder configuration page and validated.
4.6.5 Basic information
You already processed the basic information in section 4.6.2. For this reason, the values on this page
should already be correct.
4.6.6 Encoder configuration
• Check or edit each of the parameters of the encoder configuration.
If you have transferred setpoints under Section 4.6.4, then they are already entered in the appropriate
parameter. You can then transfer them using "Enable editing", "Transmit" and then check and validate
them.
184
1
2
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English