Special Functions Of The Safetytool - Festo CAMC-G-S3 Manual

4 Commissioning
4.7

Special functions of the SafetyTool

4.7.1 Changing a password
When parameterisation is active, you can change the password at any time.
1. Open the "Change password" dialog with the menu command [Tools] [Change password].
Fig. 4.5 Changing a password
2. Enter the current password under "Password".
3. Enter the new password twice under "New password" and "Confirm password".
4. Confirm with "OK".
The new password is immediately active in the safety module.
4.7.2 Setting the factory settings
To reset the safety module to the factory settings (è Section 4.4.1):
1. When the online connection is active, launch the SafetyTool (è Section 4.6).
2. Select the online session variant "Display parameterisation" (no password required).
3. It is possible that deviating basic information is then displayed, which you should confirm with OK.
4. The safety module is reset with the menu command [Tools] [Set factory settings]. For this, the user
name is queried (logged in the permanent diagnostic memory).
5. The parameter is then read from the safety module. Confirm again any deviating basic information.
6. Exit the SafetyTool.
4.7.3 Plausibility check
The plausibility check can be carried out at any time during a parameterisation session.
• Open the "Plausibility check" using the menu command [Tools] [Check parameters for plausibility].
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English 193