Festo CAMC-G-S3 Manual page 182

4 Commissioning
Click "Enabling editing" and tick the checkboxes of the deviating parameters under "Transmit".
The "Transmit" button loads the selected parameters into the safety module.
This means that the parameters are, for now, invalid. Check the parameters by comparing the values
under "Setpoint" and "Actual value". Confirm the test by ticking the checkbox under "Checked".
Then you should validate them using the "Validate" button.
182 Festo – GDCP-CAMC-G-S3-EN – 1406NH – English