Festo CAMC-G-S3 Manual page 283

A Technical appendix
Fig. A.8 Configure trace data
With the exception of "Freely selectable CO ...", you can set the entries directly.
A special dialog box is opened for the freely-selectable COs (communication objects):
Fig. A.9 Freely selectable communication object
1. Firstly, activate the "CAMC-G-S3: Safety Module" tab for the measurement data of the safety module.
2. Under "Freely selectable CO", enter the number as a hexadecimal value. The number corresponds to
the parameter number without "P" and the period. In the example, "639" stands for P06.39 – actual
value of the safe speed. The parameter number is displayed at the bottom.
You can find useful parameters, for example, in èSection B.2, Tab. B.10 "Diagnostic parameters"
3. Under "Filter", you can specify a mask, e. g. for bit arrays or other digital data.
4. Under "Unit of measurement", select the correct entry for the measured variable, so that it is dis­
played correctly later on in the diagram.
To change the settings, simply select the "Freely selectable CO ..." item again.
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English 283