Festo CAMC-G-S3 Manual page 177

4 Commissioning
For validation after the check, tick the appropriate checkbox in the "Checked" column and validate the
selected parameters with the "Validate" button. Only then have the parameters been correctly trans­
ferred to the safety module.
The "Valid" column displays whether the actual values of the parameters are valid, i.e. validated.
Symbol Status
Parameter not yet validated.
Parameter is validated.
Tab. 4.8 Display of the validity of the parameters
Plausibility check
During the parameterisation session, the SafetyTool carries out various plausibility checks.
This ranges from monitoring of the range limits through to logical testing of the rotational speed limits
(upper rotational speed limit may not be below the minimum rotational speed, lower limits must be less
than the upper limits, etc.). You can also carry out the plausibility check manually è Section 4.7.3.
Enabling and permanently saving in the device
After parameters have been changed, they must be saved permanently in the safety module. In addi­
tion, consistency of the parameter set is secured through a unique full validation code. The non-volatile
saving and calculation of the validation code is implemented using the appropriate button on the "Fin­
ish" page.
If a parameterisation session was active in the SafetyTool with write access, then a restart is carried out
automatically when the SafetyTool is exited.
Save parameterised intermediate states (without full validation):
The function "Parameterisation / Save parameters permanently in the safety module" saves the para­
meters, although they are not "fully validated". The safety module detects this status on restarting and
switches to the safe basic status.
Standard and expert parameters
Some of the parameters are indicated as "Expert parameters" or are displayed in their own tab "Expert
parameters".
Please note
Expert parameters do not normally need to be changed. Changes are only needed when
actually required.
Status of the parameter groups
Each page in the SafetyTool contains a so-called parameter group. During an online session, the status
of this parameter group is displayed by the LED symbol in the navigation tree:
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English 177