Festo CAMC-G-S3 Manual page 39

2 Product description of safety module CAMC-G-S3
Basic information
No. Name
P06.42 Unit to be displayed for speeds.
P06.43 Numerator, altered time base for
speeds of type UserDefined.
P06.44 Denominator, altered time base for
speeds of type UserDefined.
P06.45 Number of displayed post-decimal pos­
itions for speeds.
P06.46 Unit to be displayed for accelerations.
P06.47 Numerator, altered time base for accel­
erations of type UserDefined.
P06.48 Denominator, altered time base for ac­
celerations of type UserDefined.
P06.49 Number of displayed post-decimal pos­
itions for accelerations.
P06.4A Numerator, total gear ratio between
motor and axle.
P06.4B Denominator, total gear ratio between
motor and axle.
Tab. 2.8 Parameters for basic information
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English
Description
Unit to be displayed for speeds. Selecting "User­
Defined" means that no unit is displayed. If the
position is UserDefined, then the speed must be
too.
Numerator, altered time base for speeds of type
"UserDefined".
Denominator, altered time base for speeds of
type "UserDefined".
Number of displayed post-decimal positions for
speeds.
Unit to be displayed for accelerations. Selecting
UserDefined means that no unit is displayed. If
the position is "UserDefined", then the accelera­
tion must be too.
Numerator, altered time base for accelerations of
type "UserDefined".
Denominator, altered time base for accelerations
of type "UserDefined".
Number of displayed post-decimal positions for
accelerations.
Numerator, total gear ratio between motor and
axle.
Denominator, total gear ratio between motor and
axle.
39