Festo CAMC-G-S3 Manual page 225

5 Operation
Error group 59 Internal safety module error
No. Code Message
59-8 80F8h Internal monitoring, processor 1 - 2
Cause
Action
59-9 Other unexpected error
80F9h
Cause
Action
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English
– Serious internal error in the safety module: Error detected while
dynamising internal signals
– Disrupted programme sequence, stack error or OP code test
failed, processor exception / interrupt.
Check whether the error recurs after a reset. If it does:
• Module faulty, replace.
Triggering of internal programme sequence monitoring.
• Check the firmware version of the basic unit and the version of
the safety module – update available?
• Safety module faulty; replace.
Reaction
Fixed [8]
Fixed [8]
225