Basic Principles Of Parameterisation Of The Safety Module - Festo CAMC-G-S3 Manual

4 Commissioning
4.4

Basic principles of parameterisation of the safety module

4.4.1 Factory setting
For simplified parameterisation, in the delivery status, or after the factory setting is reset, some func­
tions are activated and standard values are preset.
Tab. 4.5 offers an overview of the most important settings.
Page Factory setting
Digital inputs
DIN40 Sensor type:
Operating mode:
Discrepancy time:
Source for test pulse: None
DIN 41 Sensor type:
Operating mode:
Discrepancy time:
Source for test pulse: None
DIN 42 Sensor type:
Operating mode:
Discrepancy time:
Source for test pulse: None
DIN 43 Sensor type:
Operating mode:
Discrepancy time:
Source for test pulse: None
DIN 44 Sensor type:
Source for test pulse: None
DIN 45 Sensor type:
Source for test pulse: None
DIN 46 Sensor type:
Source for test pulse: None
DIN 47 Sensor type:
Source for test pulse: None
DIN48 Sensor type:
Source for test pulse: None
DIN 49 Sensor type:
Source for test pulse: None
Safety functions
STO Request:
Automatic restart:
Automatic activation
of SBC:
Terminate request:
168
Emergency stop switching device
Equivalent
100 ms
Not defined
Equivalent
100 ms
Not defined
Equivalent
100 ms
Not defined
Equivalent
100 ms
Brake feedback
Mode selector switch
Mode selector switch
Mode selector switch
Fault acknowledgment
Terminate safety function
DIN40
No
Yes
DIN49, rising edge
Festo – GDCP-CAMC-G-S3-EN – 1406NH – English
Allocation
STO and SBC request
Not used
Not used
Not used
Not used
Not used
Not used
Not used
Fault acknowledg­
ment request
Rising edge: Termin­
ate STO, SS1 and
SBC
–