Table of Contents
Advertisement
For Texas Instruments synchronous serial frame format, the SSPFSSOUT pin is pulsed for one
serial clock period starting at its rising edge prior to the transmission of each frame. For this
frame format, both the PrimeCell SSP and the off-chip slave device drive their output data
on the rising edge of SSPCLKOUT and latch data from the other device on the falling edge.
Unlike the full-duplex transmission of the other two frame formats, the National
Semiconductor Microwire format uses a special master-slave messaging technique which
operates at half-duplex. In this mode, an 8-bit control message is transmitted to the off-chip
slave when a frame begins. During this transmit, the SSS receives no incoming data. After
the message has been sent, the off-chip slave decodes it and responds with the requested
data after waiting one serial clock after the last bit of the 8-bit control message has been
sent. The returned data can be 4-16 bits in length making the total frame length in the range
of 13-25 bits.
23.3.13
Texas Instruments synchronous serial frame format
Figure 67 shows the Texas Instruments synchronous serial frame format for a single
transmitted frame.
SSPCLKOUT/
SSPCLKIN
SSPFSSOUT/
SSPFSSIN
SSPTXD/
SSPRXD
nSSPOE
Figure 67.
In this mode, SSPCLKOUT and SSPFSSOUT are forced LOW and the transmit data line SSPTXD
is tristated whenever the PrimeCell SSP is idle. When the bottom entry of the transmit FIFO
contains data, SSPFSSOUT is pulsed HIGH for one SSPCLKOUT period. The value to be
transmitted is also transferred from the transmit FIFO to the serial shift register of the
transmit logic. On the next rising edge of SSPCLKOUT, the MSB of the 4-bit to 16-bit data
frame is shifted out on the SSPTXD pin. In a similar way, the MSB of the received data is
shifted onto the SSPRXD pin by the off-chip serial slave device.
Both the PrimeCell SSP and the off-chip serial slave device then clock each data bit into
their serial shifter on the falling edge of each SSPCLKOUT. The received data is transferred
W7500 Datasheet Version1.0.0
MSB
Texas Instruments synchronous serial frame format, single transfer
4 to 16 bits
LSB
484 / 512
Advertisement
Table of Contents
