Storing Cdrs On The Device - AudioCodes Mediant 4000 SBC User Manual

User's Manual
769.
2. Open the Call Detail Record Settings page (Troubleshoot menu > Troubleshoot tab
> Call Detail Record folder > Call Detail Record Settings).
Figure 52-7: CDR Parameters in Advanced Parameters Page
3. Configure the following parameters:
•
In the 'CDR Server IP Address' field (CDRSyslogServerIP), enter the IP address
of the server to where you want the CDRs sent.
•
From the 'CDR Report Level' drop-down list (CDRReportLevel), select the stage
of the call at which you want CDRs to be generated and sent.
•
(Applicable only to SBC) From the 'Media CDR Report Level' drop-down list
(MediaCDRReportLevel), select the stage of the call at which you want CDRs to
be generated and sent.
•
From the 'CDR Syslog Sequence Number' drop-down list (CDRSyslogSeqNum),
enable or disable the inclusion of the sequence number (S=) in CDR Syslog
messages.
4. Click Apply.
Note:
•
If you do not configure an IP address for a CDR server, the device sends CDRs to
the Syslog server, as configured in 'Enabling Syslog' on page 769.
•
The device sends CDRs only for dialog-initiating INVITE messages (call start), 200
OK responses (call connect) and BYE messages (call end). If you want to enable
the generation of CDRs for non-call SIP dialogs (such as SUBSCRIBE, OPTIONS,
and REGISTER), use the EnableNonCallCdr parameter.

52.2.4 Storing CDRs on the Device

The CDRs generated by the device can also be stored locally on the device (RAM or
internal SD card). The SD card provides storage capacity of 4 GB for Mediant 4000 and 16
GB for Mediant 4000B.
Note:
deleted.
You can specify the calls (configuration entities) for which you wish to create CDRs and
store locally. This is done using Logging Filter rules in the Logging Filters table. For
Version 7.2
When the device is reset or powered off, locally stored CDRs on RAM are
52. Reporting Information to External Party
747 Mediant 4000 SBC