AudioCodes Mediant 4000 SBC User Manual page 359

User's Manual
Parameter
Tags
tags
[IPGroup_Tags]
Call Setup Rules Set ID
call-setup-rules-set-id
[IPGroup_CallSetupRulesSe
tId]
Quality of Experience
QoE Profile
qoe-profile
[IPGroup_QOEProfile]
Bandwidth Profile
bandwidth-profile
[IPGroup_BWProfile]
Message Manipulation
Inbound Message
Manipulation Set
inbound-mesg-manipulation-
set
[IPGroup_InboundManSet]
Outbound Message
Manipulation Set
outbound-mesg-
manipulation-set
Version 7.2
Note: For IP-to-IP Routing rules that are configured for destination
based on tags (i.e., 'Destination Type' parameter configured to
Destination Tag), the parameter is applicable only to the source IP
Group and the device searches the Dial Plan for a dial plan rule that
matches the prefix of the destination number only. For more
information on routing based on destination tags, see Using Dial Plan
Tags for Routing Destinations on page 551.
Assigns a Dial Plan tag that is used to determine whether the incoming
SIP dialog is sent to this IP Group. The parameter is used when IP-to-
IP Routing rules are configured for destination based on tags (i.e.,
'Destination Type' parameter configured to Destination Tag). For
more information on routing based on destination tags, see Using Dial
Plan Tags for Routing Destinations on page 551.
Assigns a Call Setup Rule Set ID to the IP Group. The device runs the
Call Setup rule immediately before the routing stage (i.e., only after the
classification and manipulation stages).
By default, no value is assigned.
To configure Call Setup Rules, see Configuring Call Setup Rules on
page 386.
Assigns a Quality of Experience Profile rule.
By default, no value is defined.
To configure Quality of Experience Profiles, see ''Configuring Quality
of Experience Profiles'' on page 311.
Assigns a Bandwidth Profile rule.
By default, no value is defined.
To configure Bandwidth Profiles, see ''Configuring Bandwidth Profiles''
on page 316.
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the inbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see Configuring SIP
Message Manipulation on page 395.
Note: The IPGroup_SIPGroupName parameter overrides inbound
message manipulation rules (assigned to the
IPGroup_InboundManSet parameter) that manipulate the host name in
Request-URI, To, and/or From SIP headers. If you want to manipulate
the host name using message manipulation rules in any of these SIP
headers, you must apply your manipulation rule (Manipulation Set ID)
to the IP Group as an Outbound Message Manipulation Set (see the
IPGroup_OutboundManSet parameter), when the IP Group is the
destination of the call.
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the outbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see ''Configuring SIP
359
Description
17. Control Network
Mediant 4000 SBC