For detailed descriptions of the SNMP parameters, see ''SNMP Parameters'' on page 810.
To configure SNMP community strings:
1.
Open the SNMP Community Settings page (Setup menu > Administration tab >
SNMP folder > SNMP Community Settings).
2.
Configure SNMP community strings for access privileges:
•
Under the Read Only Community Strings group, configure read-only
community strings (see the table below).
•
Under the Read/Write Community Strings group, configure read-write
community strings (see the table below).
3.
Configure a community string for SNMP traps: Under the Misc. Settings group, in the
'Trap Community String' field, configure a community string (see the table below).
Figure 8-1: Configuring SNMP Trap Community String
4.
Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
To delete a community string, delete the configured string, click Apply., and then reset the
device with a save-to-flash for your settings to take effect.
Table 8-1: SNMP Community String Parameter Descriptions
Parameter
User's Manual
Description
88
Mediant 4000 SBC
Document #: LTRT-40203