Syslog, Cdr And Debug Parameters - AudioCodes Mediant 4000 SBC User Manual

Parameter
Test Call DTMF String
configure troubleshoot >
test-call settings > testcall-
dtmf-string
[TestCallDtmfString]
Test Call ID
configure troubleshoot >
test-call settings > testcall-
id
[TestCallID]
Test Call Rules Table
Test Call Rules
configure troubleshoot
>test-call test-call-table
[Test_Call]

60.3.3 Syslog, CDR and Debug Parameters

The Syslog, CDR and debug parameters are described in the table below.
Parameter
Enable Syslog
configure troubleshoot > syslog
> syslog
[EnableSyslog]
Syslog Server IP
configure troubleshoot > syslog
User's Manual
Table 60-18: SIP Test Call Parameters
Defines the DTMF tone that is played for answered test calls (incoming
and outgoing).
The DTMF string can be up to 15 strings. The default is "3212333". If no
string is defined (empty), DTMF is not played.
Defines the test call prefix number (ID) of the simulated phone on the
device. Incoming calls received with this called prefix number are
identified as test calls.
This can be any string of up to 15 characters. By default, no number is
defined.
Note: The parameter is only for testing incoming calls destined to this
prefix number.
Defines Test Call rules.
[ Test_Call ]
FORMAT Test_Call_Index = Test_Call_EndpointURI,
Test_Call_CalledURI, Test_Call_RouteBy, Test_Call_IPGroupName,
Test_Call_DestAddress, Test_Call_DestTransportType,
Test_Call_SIPInterfaceName, Test_Call_ApplicationType,
Test_Call_AutoRegister, Test_Call_UserName, Test_Call_Password,
Test_Call_CallParty, Test_Call_MaxChannels, Test_Call_CallDuration,
Test_Call_CallsPerSecond, Test_Call_TestMode,
Test_Call_TestDuration, Test_Call_Play, Test_Call_ScheduleInterval,
Test_Call_QOEProfile, Test_Call_BWProfile;
[ \Test_Call ]
For more information, see ''Configuring Test Call Endpoints'' on page
783.
Table 60-19: Syslog, CDR and Debug Parameters
Determines whether the device sends logs and error messages (e.g.,
CDRs) generated by the device to a Syslog server.

[0] Disable (default)

[1] Enable
Note:

If you enable Syslog, you must enter an IP address of the Syslog
server (using the SyslogServerIP parameter).

Syslog messages may increase the network traffic.

To configure Syslog SIP message logging levels, use the
GwDebugLevel parameter.
Defines the IP address (in dotted-decimal notation) of the computer
on which the Syslog server is running. The Syslog server is an
application designed to collect the logs and error messages
Description
Description
830
Mediant 4000 SBC
Document #: LTRT-40203