AudioCodes Mediant 4000 SBC User Manual page 274

Parameter
Persistent Connection
http-persistent-
connection
[HTTPRemoteServices_Persisten
tConnection]
Number of Sockets
http-num-sockets
[HTTPRemoteServices_NumOfS
ockets]
Login
Login Needed
http-login-needed
[HTTPRemoteServices_LoginNe
eded]
Username
rest-user-name
[HTTPRemoteServices_AuthUser
Name]
Password
rest-password
[HTTPRemoteServices_AuthPas
sword]
Security
TLS Context
rest-tls-context
[HTTPRemoteServices_TLSCont
ext]
Verify Certificate
rest-verify-certificates
[HTTPRemoteServices_VerifyCer
tificate]
User's Manual
the first (primary) host. If the host does not respond, the
device sends the traffic to the next available host. If the
primary host becomes available again, the device sends the
traffic to the primary host.

[2] Sticky Next = Similar to Sticky Primary, but if the primary
host does not respond, the device sends the traffic to the next
available host and continues sending traffic to this host even if
the primary host becomes available again.
Defines whether the HTTP connection with the host remains open
or is only opened per request.

[0] Disable = Connection is not persistent and closes when the
device detects inactivity. The device uses HTTP keep-alive
messages to detect inactivity.

[1] Enable = (Default) Connection remains open (persistent)
even during inactivity. The device uses HTTP keep-alive /
HTTP persistent connection messages to keep the connection
open.
Defines how many sockets (connection) are established per
remote host.
The valid value is 1 to 10. The default is 1.
Enables the use of proprietary REST API Login and Logout
commands for connecting to the remote host. The commands
verify specific information (e.g., software version) before allowing
connectivity with the device.

[0] Disable = Commands are not used.

[1] Enable (default)
Defines the username for HTTP authentication.
The valid value is a string of up to 80 characters. The default is
"user".
Defines the password for HTTP authentication.
The valid value is a string of up to 80 characters. The default is
"password".
Assigns a TLS Context for connection with the remote host.
By default, no value is defined.
To configure TLS Contexts, see ''Configuring TLS Certificate
Contexts'' on page 103.
Note: The parameter is applicable only if the connection is
HTTPS.
Enables certificate verification when connection with the host is
based on HTTPS.

[0] Disable = (Default) No certificate verification is done.

[1] Enable = The device verifies the authentication of the
274
Mediant 4000 SBC
Description
Document #: LTRT-40203