AudioCodes Mediant 4000 SBC User Manual page 388

configured to "false" for an empty condition.

"false": Indicates that if the condition is met, the device attempts to route the call to the
next matching routing rule (if configured). If the condition is not met, the device routes
the call according to the selected routing rule.
As the default result of a Call Setup rule is always "true", please adhere to the following
guidelines when configuring the 'Action Type' field to Exit: If, for example, you want to exit
the Call Setup Rule Set ID with "true" when LDAP query result is found and "false" when
LDAP query result is not found:

Incorrect -this rule will always exit with result = True:
Condition: ldap.found exists

Correct:
•
Single rule:
Condition: ldap.found !exists
•
Set of rules:
Condition: ldap.found exists
Condition: <leave it blank>
Note: If the source and/or destination numbers are manipulated by the Call Setup
rules, they revert to their original values if the device moves to the next routing rule.
The following procedure describes how to configure Call Setup Rules through the Web
interface. You can also configure it through ini file (CallSetupRules) or CLI (configure voip >
message call-setup-rules).

To configure a Call Setup rule:
1. Open the Call Setup Rules table (Setup menu > Signaling & Media tab > SIP
Definitions folder > Call Setup Rules).
2. Click New; the following dialog box appears:
Figure 18-2: Call Setup Rules Table - Add Dialog Box
3. Configure a Call Setup rule according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
User's Manual
Action Type: Exit
Action Type: Exit
Action Type: Exit
Action Type: Exit
388
Mediant 4000 SBC
Action Value: True
Action Value: False
Action Value: True
Action Value: False
Document #: LTRT-40203