AudioCodes Mediant 4000 SBC User Manual page 660

Warning:
•
When loading an ini file as described in this section, parameters not included in
the ini file are restored to default settings. If you want to keep the device's current
configuration settings and also apply the settings specified in the ini file, load the
file through the Auxiliary Files page, as described in Loading Auxiliary Files
through Web Interface on page 627.
•
Regarding device reset when loading a configuration file:
√
ini File: The device automatically resets for the settings to take effect.
√
CLI Script File: The device resets only if the file contains the reload command
(on the last line). For more information on this command, refer to the CLI
Reference Guide.
√
CLI Startup Script File: The device automatically resets twice for the settings to
take effect.

To load a configuration file to the device:
1. Open the Configuration File page:
•
Toolbar: From the Actions drop-down menu, choose Configuration File
•
Navigation tree: Setup menu > Administration tab > Maintenance folder >
Configuration File
2. Depending on the file type that you want to load:
•
ini File:
a.
b.
•
CLI Script File:
a.
b.
•
CLI Startup Script File:
a.
b.
If the device resets (see note at the beginning of this section), you are prompted to log in
again to the Web interface.
User's Manual
Figure 40-3: Loading ini File
Click Browse, and then navigate to and select the file.
Click Load INI File:
Figure 40-4: Loading CLI Script File
Click Browse, and then navigate to and select the file.
Click Load CLI Script File.
Figure 40-5: Loading CLI Startup Script File
Click Browse, and then navigate to and select the file.
Click Load CLI Startup Script:
660
Mediant 4000 SBC
Document #: LTRT-40203