Resource Allocation Indication Parameters; Ha Parameters - AudioCodes Mediant 4000 SBC User Manual

Parameter
cdr-format sbc-cdr-format
[SBCCDRFormat]

60.3.4 Resource Allocation Indication Parameters

The Resource Allocation Indication (RAI) parameters are described in the table below.
Parameter
[EnableRAI]
[RAIHighThreshold]
[RAILowThreshold]
[RAILoopTime]
60.4

HA Parameters

The High Availability (HA) parameters are described in the table below.
Parameter
HA Device Name
configure network > high-
User's Manual
[ SBCCDRFormat ]
FORMAT SBCCDRFormat_Index = SBCCDRFormat_CDRType,
SBCCDRFormat_FieldType, SBCCDRFormat_Title,
SBCCDRFormat_RadiusType, SBCCDRFormat_RadiusID;
[ \SBCCDRFormat ]
For more information, see Customizing CDRs for SBC Calls on page
743.
Table 60-20: RAI Parameters
Enables Resource Available Indication (RAI) alarm generation if the
device's busy endpoints exceed a user-defined threshold, configured by
the RAIHighThreshold parameter. When enabled and the threshold is
crossed, the device sends the SNMP trap, acBoardCallResourcesAlarm.

[0] = (Default) Disable

[1] = Enable
Note: For the parameter to take effect, a device reset is required.
Defines the high threshold percentage of total calls that are active (busy
endpoints). When the percentage of the device's busy endpoints
exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default is 90.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of "enabled" endpoints.
Defines the low threshold percentage of total calls that are active (busy
endpoints).
When the percentage of the device's busy endpoints falls below this low
threshold, the device sends an SNMP acBoardCallResourcesAlarm
alarm trap with a 'cleared' alarm status.
The range is 0 to 100%. The default is 90%.
Defines the time interval (in seconds) that the device periodically checks
call resource availability.
The valid range is 1 to 200. The default is 10.
Table 60-21: HA Parameters
Defines a name for the active device, which is displayed on the Home
page to indicate the active device.
836
Description
Description
Description
Document #: LTRT-40203
Mediant 4000 SBC