Quality Of Service Parameters - AudioCodes Mediant 4000 SBC User Manual

Parameter
Messages
configure network >
network-settings > icmp-
disable-unreachable
[DisableICMPUnreachable]
Send and Receive ICMP
Redirect Messages
configure network >
network-settings > icmp-
disable-redirec
[DisableICMPRedirects]
Static Routes Table
Static Routes
configure network > static
[StaticRouteTable]

60.2.4 Quality of Service Parameters

The Quality of Service (QoS) parameters are described in the table below.
Parameter
Layer-2 Class Of Service (CoS) Parameters (VLAN Tag Priority Field)
DiffServ Table
configure network > qos vlan-mapping
[DiffServToVlanPriority]
User's Manual

[0] Enable = (Default) Device sends these messages.

[1] Disable = Device does not send these messages.
Enables sending and receiving of ICMP Redirect messages.

[0] Enable = (Default) Device sends and accepts these messages.

[1] Disable = Device rejects these messages and also does not send
them.
Defines up to 30 static IP routes for the device.
The format of the ini file table parameter is as follows:
[ StaticRouteTable ]
FORMAT StaticRouteTable_Index = StaticRouteTable_DeviceName,
StaticRouteTable_Destination, StaticRouteTable_PrefixLength,
StaticRouteTable_Gateway, StaticRouteTable_Description;
[ \StaticRouteTable ]
For a description of the parameter, see ''Configuring Static IP Routes''
on page 137.
Table 60-12: QoS Parameters
The table configures DiffServ-to-VLAN Priority mapping. For
each packet sent to the LAN, the VLAN Priority of the packet
is set according to the DiffServ value in the IP header of the
packet.
The format of this ini file is as follows:
[ DiffServToVlanPriority ]
FORMAT DiffServToVlanPriority_Index =
DiffServToVlanPriority_DiffServ,
DiffServToVlanPriority_VlanPriority;
[ \DiffServToVlanPriority ]
For example:
DiffServToVlanPriority 0 = 46, 6;
DiffServToVlanPriority 1 = 40, 6;
DiffServToVlanPriority 2 = 26, 4;
DiffServToVlanPriority 3 = 10, 2;
For more information, see Configuring Quality of Service on
page 148.
Note: For the parameter to take effect, a device reset is
required.
822
Description
Description
Document #: LTRT-40203
Mediant 4000 SBC