AudioCodes Mediant 4000 SBC User Manual page 366

Parameter
voip-network proxy-set > srd-
id
[ProxySet_SRDName]
General
Index
configure voip > voip-network
proxy-set
[ProxySet_Index]
Name
proxy-name
[ProxySet_ProxyName]
SBC IPv4 SIP Interface
sbcipv4-sip-int-name
[ProxySet_SBCIPv4SIPInterfa
ceName]
SBC IPv6 SIP Interface
sbcipv6-sip-int-name
[ProxySet_SBCIPv6SIPInterfa
ceName]
TLS Context Index
tls-context-name
[ProxySet_TLSContextName]
Keep Alive
User's Manual
Note:

The parameter is mandatory and must be configured first before
you can configure the other parameters in the table.

To configure SRDs, see Configuring SRDs on page 331.
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines a descriptive name, which is used when associating the row
in other tables.
The valid value is a string of up to 40 characters.
Note: Each row must be configured with a unique name.
Assigns an IPv4-based SIP Interface for SBC calls to the Proxy Set.
Note:

At least one SIP Interface must be assigned to the Proxy Set.

The parameter appears only if you have configured a network
interface with an IPv4 address in the IP Interfaces table (see
Configuring IP Network Interfaces on page 129).

To configure SIP Interfaces, see ''Configuring SIP Interfaces'' on
page 341.
Assigns an IPv6-based SIP Interface for SBC calls to the Proxy Set.
Note:

At least one SIP Interface must be assigned to the Proxy Set.

The parameter appears only if you have configured a network
interface with an IPv6 address in the IP Interfaces table.
Assigns a TLS Context (SSL/TLS certificate) to the Proxy Set.
By default, no TLS Context is assigned. If you assign a TLS Context,
the TLS Context is used as follows:

Incoming calls: If the 'Transport Type' parameter (in this table) is
set to TLS and the incoming call is successfully classified to an IP
Group based on the Proxy Set, this TLS Context is used. If the
'Transport Type' parameter is set to UDP or classification to this
Proxy Set fails, the TLS Context is not used. Instead, the device
uses the TLS Context configured for the SIP Interface (see
''Configuring SIP Interfaces'' on page 341) used for the call;
otherwise, the default TLS Context (ID 0) is used.

Outgoing calls: If the 'Transport Type' parameter is set to TLS
and the outgoing call is sent to an IP Group that is associated
with this Proxy Set, this TLS Context is used. Instead, the device
uses the TLS Context configured for the SIP Interface used for
the call; otherwise, the default TLS Context (ID 0) is used. If the
'Transport Type' parameter is set to UDP, the device uses UDP to
communicate with the proxy and no TLS Context is used.
To configure TLS Contexts, see ''Configuring TLS Certificate
Contexts'' on page 103.
366
Mediant 4000 SBC
Description
Document #: LTRT-40203