Configuring Ldap Servers - AudioCodes Mediant 4000 SBC User Manual

15.4.4 Configuring LDAP Servers

The LDAP Servers table lets you configure up to 500 LDAP servers. The table defines the
address and connectivity settings of the LDAP server. The LDAP server can be configured
for SIP-related queries (e.g., routing and manipulation) or LDAP-based management user
login authentication and authorization (username-password).
The following procedure describes how to configure an LDAP server through the Web
interface. You can also configure it through ini file (LdapConfiguration) or CLI (configure
system > ldap ldap-configuration).
Note: When you configure an LDAP server, you need to assign it an LDAP Server
Group. Therefore, before you can configure an LDAP server in the table, you must
first configure at least one LDAP Server Group in the LDAP Server Groups table (see
''Configuring LDAP Server Groups'' on page 240).

To configure an LDAP server:
1. Open the LDAP Servers table (Setup menu > IP Network tab > RADIUS & LDAP
folder > LDAP Servers).
2. Click New; the following dialog box appears:
3. Configure an LDAP server according to the parameters described in the table below.
4. Click Apply.
Table 15-9: LDAP Servers Table Parameter Descriptions
Parameter
General
Index
[LdapConfiguration_Index]
LDAP Servers Group
User's Manual
Figure 15-24: LDAP Servers Table - Add Dialog Box
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Assigns the LDAP server to an LDAP Server Group, configured in
the LDAP Server Groups table (see ''Configuring LDAP Server
Description
242
Mediant 4000 SBC
Document #: LTRT-40203