Configuring Sbc User Info Table Through Cli - AudioCodes Mediant 4000 SBC User Manual

User's Manual
Parameter
[SBCUserInfoTable_Username]
Password
[SBCUserInfoTable_Password]
IP Group
[SBCUserInfoTable_IPGroupName]
Status
[SBCUserInfoTable_Status]

37.6.2.2 Configuring SBC User Info Table through CLI

The SBC User Info table can be configured in the CLI using the following commands:

To add and/or modify a user (example):
# configure voip
(config-voip)# sip-definition proxy-and-registration
(sip-def-proxy-and-reg)# user-info sbc-user-info <index, e.g.,
1>
(sbc-user-info-1)# username JohnDee
(sbc-user-info-1)# <activate | exit>

To delete a specific user, use the no command:
(sip-def-proxy-and-reg)# no user-info sbc-user-info <index,
e.g., 1>

To view all table entries:
(sip-def-proxy-and-reg)# user-info sbc-user-info display
---- sbc-user-info-0 ----
local-user (JohnDee)
username (userJohn)
password (s3fn+fn=)
ip-group-id (1)
status (not-resgistered)
---- sbc-user-info-1 ----
local-user (SuePark)
username (userSue)
password (t6sn+un=)
ip-group-id (1)
status (not-resgistered)

To view a specific entry (example):
(sip-def-proxy-and-reg)# user-info sbc-user-info <index, e.g.,
0>
(sbc-user-info-0)# display
local-user (JohnDee)
username (userJohn)
password (s3fn+fn=)
ip-group-id (1)
status (not-resgistered)
Version 7.2
authentication is necessary.
The valid value is a string of up to 40 characters.
Defines the password for registering the user when
authentication is necessary.
The valid value is a string of up to 20 characters.
Assigns an IP Group to the user and is used as the Request-
URI source host part for the AOR in the database.
To configure IP Groups, see ''Configuring IP Groups'' on page
349.
(Read-only field) Displays the status of the user - "Registered"
or "Not Registered".
637
37. Auxiliary Files
Description
Mediant 4000 SBC