User's Manual
26.3
Using the Proprietary SIP X-AC-Action Header
You can use AudioCodes proprietary SIP header, X-AC-Action in message manipulation
rules to trigger certain actions. These actions can be used to support, for example,
interworking of SIP-I and SIP endpoints for the ISUP SPIROU variant (see Enabling
Interworking of SIP and SIP-I Endpoints on page 563).
The following actions are supported by the X-AC-Action header:
To disconnect a call (optionally, after a user-defined time):
X-AC-Action: 'disconnect'
X-AC-Action: 'disconnect;delay=<time in ms>'
To resume a previously suspended call:
X-AC-Action: 'abort-disconnect'
To automatically reply to a message without forwarding the response to the
other side:
X-AC-Action: 'reply'
To automatically reply to a message with a specific SIP response without
forwarding the response to the other side:
X-AC-Action: 'reply;response=<response code, e.g., 200>]'
To switch to a different IP Profile for the call (re-INVITE only), as defined in the
IP Group:
X-AC-Action: 'switch-profile;profile-name=<IP Profile Name>'
X-AC-Action: 'switch-profile;profile-name=<IP Profile
Name>;reason=<PoorInVoiceQuality or
PoorInVoiceQualityFailure>]'
If the IP Profile name contains one or more spaces (e.g., "ITSP NET"), enclose the
name in double quotation marks, for example:
X-AC-Action: 'switch-profile;profile-name="ITSP NET"'
For example, to use the X-AC-Action header to switch IP Profiles from "ITSP-Profile-1" to
"ITSP-Profile-2" during a call for an IP Group (e.g., IP PBX) if the negotiated media port
changes to 7550, perform the following configuration:
1.
In the IP Profiles table, configure two IP Profiles ("ITSP-Profile-1" and "ITSP-Profile-
2").
2.
In the IP Groups table, assign the main IP Profile ("ITSP-Profile-1") to the IP Group
using the 'IP Profile' parameter.
3.
In the Message Manipulations table, configure the following manipulation rule:
•
Manipulation Set ID: 1
•
Message Type: reinvite.request
•
Condition: body.sdp regex (.*)(m=audio 7550 RTP/AVP)(.*)
•
Action Subject: header.X-AC-Action
•
Action Type: Add
•
Action Value: 'switch-profile;profile-name=ITSP-Profile-2'
4.
In the IP Groups table, assign the Message Manipulation rule to the IP Group, using
the 'Inbound Message Manipulation Set' parameter.
In the above example, if the device receives from the IP Group a re-INVITE message
whose media port value is 7550, the device adds the SIP header "X-AC-Action: switch-
profile;profile-name=ITSP-Profile-2"to the incoming re-INVITE message. As a result of
Version 7.2
539
26. SBC Manipulations
Mediant 4000 SBC