AudioCodes Mediant 4000 SBC User Manual page 786

Parameter
[Test_Call_BWProfile]
Authentication
Note: These parameters are applicable only if the 'Call Party' parameter (see below) is configured to
Caller.
Auto Register
auto-register
[Test_Call_AutoRegister]
Username
user-name
[Test_Call_UserName]
Password
password
[Test_Call_Password]
Test Setting
Call Party
call-party
[Test_Call_CallParty]
Maximum Channels for
Session
max-channels
[Test_Call_MaxChannels]
Call Duration
call-duration
[Test_Call_CallDuration]
Calls per Second
calls-per-second
[Test_Call_CallsPerSecond]
Test Mode
test-mode
[Test_Call_TestMode]
User's Manual
Profiles'' on page 316.
Enables automatic registration of the endpoint. The endpoint can
register to the device itself or to the 'Destination Address' or 'IP
Group' parameter settings (see above).

[0] Disable (default)

[1] Enable
Defines the authentication username.
By default, no username is defined.
Defines the authentication password.
By default, no password is defined.
Defines whether the test endpoint is the initiator (caller) or receiving
side (called) of the test call.

[0] Caller (default)

[1] Called
Defines the maximum number of concurrent channels for the test
session. For example, if you have configured an endpoint "101" and
you configure the parameter to "3", the device automatically creates
three simulated endpoints - "101", "102" and "103" (i.e., consecutive
endpoint URIs are assigned).
The default is 1.
Defines the call duration (in seconds).
The valid value is -1 to 100000. The default is 20. A value of 0
means infinite. A value of -1 means that the parameter value is
automatically calculated according to the values of the 'Calls per
Second' and 'Maximum Channels for Session' parameters.
Note: The parameter is applicable only if you configure 'Call Party'
to Caller.
Defines the number of calls per second.
Note: The parameter is applicable only if you configure 'Call Party'
to Caller.
Defines the test session mode.

[0] Once = (Default) The test runs until the lowest value between
the following is reached:

Maximum channels is reached for the test session,
configured by 'Maximum Channels for Session'.

Call duration ('Call Duration') multiplied by calls per second
('Calls per Second').

Test duration expires, configured by 'Test Duration'.

[1] Continuous = The test runs until the configured test duration
is reached. If it reaches the maximum channels configured for
786
Mediant 4000 SBC
Description
Document #: LTRT-40203