User's Manual
To configure basic call testing:
1.
Open the Test Call Settings page (Troubleshooting tab > Troubleshooting menu >
Test Call folder > Test Call Settings).
2.
In the 'Test Call ID' field, enter a prefix for the simulated endpoint:
3.
Click Apply.
Note:
•
The device can play DTMF tones to the remote endpoint. For more information,
see Configuring DTMF Tones for Test Calls on page 790.
•
Test calls are done on all SIP Interfaces.
57.7
Test Call Configuration Examples
Below are a few examples of test call configurations.
Single Test Call Scenario: This example describes the configuration of a simple test
call scenario that includes a single test call between a simulated test endpoint on the
device and a remote endpoint.
•
Test Call Rules table configuration:
Version 7.2
Figure 57-4: Incoming Test Call Example
Figure 57-5: Configuring Basic Test Calls
Figure 57-6: Single Test Call Example
791
57. Testing SIP Signaling Calls
Mediant 4000 SBC