Call Setup Rules Parameters; Http-Based Services - AudioCodes Mediant 4000 SBC User Manual

User's Manual

60.13.4 Call Setup Rules Parameters

The Call Setup Rules parameters are described in the table below.
Parameter
Call Setup Rules
configure voip > message
call-setup-rules
[CallSetupRules]

60.13.5 HTTP-based Services

The HTTP-based service parameters are described in the table below.
Parameter
Quality Status
configure system > http-
services > routing-qos-
status
[RoutingServerQualityStatus]
Quality Status Rate
configure system > http-
services > routing-qos-
status-rate
[RoutingServerQualityStatusRate]
Topology Status
configure system > http-
services > routing-
server-group-status
[RoutingServerGroupStatus]
Remote Web Services Table
Remote Web Services
configure system > http-services
> http-remote-services
Version 7.2
Table 60-46: Call Setup Rules Parameters
Defines Call Setup Rules that the device runs at call setup for LDAP-
based routing and other advanced routing logic requirements including
manipulation.
[ CallSetupRules ]
FORMAT CallSetupRules_Index = CallSetupRules_RulesSetID,
CallSetupRules_AttributesToQuery, CallSetupRules_AttributesToGet,
CallSetupRules_RowRole, CallSetupRules_Condition,
CallSetupRules_ActionSubject, CallSetupRules_ActionType,
CallSetupRules_ActionValue;
[ \CallSetupRules ]
For more information, see ''Configuring Call Setup Rules'' on page 407.
Table 60-47: HTTP-based Service Parameters
Enables QoS-based routing by the routing server. The device
collects QoS metrics (media and signaling) and sends them to the
routing server.

[0] Disable (default)

[1] Enable
For more information, see Configuring QoS-Based Routing by
Routing Server on page 281.
Defines the rate (in sec) at which the device sends QoS reports to
the routing server.
The valid range is 15-3600. The default is 60.
For more information, see Configuring QoS-Based Routing by
Routing Server on page 281.
Enables the reporting of the device's topology status (using the
REST TopologyStatus API command) to HTTP remote hosts.

[0] Disable (default)

[1] Enable
For more information, see ''Configuring HTTP Services'' on page
271.
Defines remote Web services.
The format of the ini file table parameter is as follows:
[HTTPRemoteServices]
60. Configuration Parameters Reference
Description
Description
919 Mediant 4000 SBC