User's Manual
15.7.1 Enabling the HTTP Proxy Application
Before you can configure HTTP-based proxy services, you must enable the HTTP Proxy
application, as described in the following procedure. Once enabled, the Web interface
displays menus in the Navigation pane that are relevant to the HTTP Proxy application.
Note:
only if it is included in the License Key installed on the device. For ordering the
feature, please contact your AudioCodes sales representative. For installing a new
License Key, see License Key on page 641.
To enable the HTTP Proxy application:
1.
Open the General Settings page (Setup menu > IP Network tab > HTTP Proxy folder
> General Settings).
2.
From the 'HTTP Proxy Application' drop-down list, select Enable.
3.
Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
15.7.2 Debugging Remote HTTP Services
You can enable the device to generate debug messages for remote Web (HTTP) services
and send them to a Syslog server.
To enable debugging of HTTP services:
1.
Open the General Settings page (Setup menu > IP Network tab > HTTP Proxy folder
> General Settings):
2.
From the 'HTTP Proxy Debug Level' drop-down list, select one of the following:
•
No Debug: Disables debugging.
•
Basic: Enables debugging and sends basic information in the Syslog.
•
Detailed: Enables debugging and sends detailed information in the Syslog.
3.
Click Apply.
Version 7.2
The HTTP Proxy application is a license-dependent feature and is available
Figure 15-53: Enabling HTTP Proxy Application
283
15. Services
Mediant 4000 SBC