AudioCodes Mediant 4000 SBC User Manual page 231

User's Manual
Note:
•
To enable and configure RADIUS-based accounting, see ''Configuring RADIUS
Accounting'' on page 750.
•
The device can send up to 201 concurrent RADIUS requests per RADIUS service
type (Accounting or Authentication), per RADIUS server (up to three servers per
service type), and per local port (up to 2 local ports). For example, 402 (201 * 2)
concurrent RADIUS requests can be sent for Authentication and 402 (201 * 2) for
Accounting.

To configure a RADIUS server:
1. Open the RADIUS Servers table (Setup menu > IP Network tab > RADIUS & LDAP
folder > RADIUS Servers).
2. Click New; the following dialog box appears:
3. Configure a RADIUS server according to the parameters described in the table below.
4. Click Apply.
Table 15-7: RADIUS Servers Table Parameter Descriptions
Parameter
Index
[RadiusServers_Index]
IP Address
ip-address
[RadiusServers_IPAddress]
Authentication Port
auth-port
[RadiusServers_AuthenticationPort]
Accounting Port
Version 7.2
Figure 15-12: RADIUS Servers Table - Add Dialog Box
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines the IP address of the RADIUS server (in dotted-decimal
notation).
Defines the port of the RADIUS Authentication server for
authenticating the device with the RADIUS server. When set to
any value other than 0, the RADIUS server is used by the
device for RADIUS-based management-user login
authentication. When set to 0, RADIUS-based login
authentication is not implemented.
The valid value is 0 to any integer. The default is 1645.
Defines the port of the RADIUS Accounting server to where the
Description
231
15. Services
Mediant 4000 SBC