Configuring The Debug Recording Server Address; Collecting Debug Recording Messages - AudioCodes Mediant 4000 SBC User Manual

Note:
•
Debug recording is collected only on the device's OAMP interface.
•
For a detailed description of the debug recording parameters, see ''Syslog, CDR
and Debug Parameters'' on page 830.

53.3.1 Configuring the Debug Recording Server Address

The procedure below describes how to configure the address of the debug recording
server to where the device sends the captured traffic. Once you configure an address, the
device generates debug recording packets for all calls. However, you can configure the
device to generate debug recording packets for specific calls, using Logging Filter rules in
the Logging Filters table (see ''Configuring Log Filter Rules'' on page 759).

To configure the debug recording server's address:
1. Open the Logging Settings page (Troubleshoot tab > Troubleshoot menu >
Logging folder > Logging Settings).
2. In the 'Debug Recording Destination IP' field, configure the IP address of the debug
capturing server.
3. In the 'Debug Recording Destination Port' field, configure the port of the debug
capturing server.
4. Click Apply.

53.3.2 Collecting Debug Recording Messages

To collect debug recording packets, use the open source packet capturing program,
Wireshark. AudioCodes proprietary plug-in files for Wireshark are required.
Note:
•
The default debug recording port is 925. You can change the port in Wireshark
(Edit menu > Preferences > Protocols > AC DR).
•
The plug-in files are per major software release of Wireshark. For more
information, contact your AudioCodes sales representative.
•
The plug-in files are applicable only to Wireshark 32-bit for Windows.

To install Wireshark and the plug-ins for debug recording:
1. Install Wireshark on your computer. The Wireshark program can be downloaded from
http://www.wireshark.org.
2. Download the proprietary plug-in files from www.audiocodes.com/downloads.
3. Copy the plug-in files to the directory in which you installed Wireshark, as follows:
User's Manual
Figure 53-7: Configuring Debug Recording Server
774
Mediant 4000 SBC
Document #: LTRT-40203