AudioCodes Mediant 4000 SBC User Manual page 389

User's Manual
Parameter
General
Index
[CallSetupRules_Index]
Rules Set ID
rules-set-id
[CallSetupRules_RulesSetID]
Query Type
query-type
[CallSetupRules_QueryType]
Query Target
query-target
[CallSetupRules_QueryTarget]
Search Key
attr-to-query
[CallSetupRules_AttributesToQuery]
Version 7.2
Table 18-2: Call Setup Rules Parameter Descriptions
Defines an index number for the new table record.
Note: Each rule must be configured with a unique index.
Defines a Set ID for the rule. You can define the same Set ID
for multiple rules to create a group of rules. You can configure
up to 10 Set IDs, where each Set ID can include up to 10 rules.
The Set ID is used to assign the Call Setup rules to a routing
rule in the routing table.
The valid value is 0 to 9. The default is 0.
Defines the type of query.

[0] None (default)

[1] LDAP = The Call Setup rule performs an LDAP query
with an LDAP server.

[2] Dial Plan = The Call Setup rule performs a query with
the Dial Plan.

[3] ENUM = The Call Setup rule performs a query with an
ENUM (E.164 Number to URI Mapping) server for retrieving
a SIP URI address for an E.164 telephone number. The
ENUM server address is configured for the IP Interface in
the IP Interfaces table ('Primary DNS' or 'Secondary DNS'
parameters) used for the call. For a configuration example,
see "Call Setup Rule Examples" on page 392.
To specify an LDAP server or Dial Plan, use the 'Query Target'
parameter (see below).
Defines one of the following, depending on the value
configured for the 'Query Type' parameter (above):

LDAP: Specifies an LDAP server (LDAP Server Group) on
which to perform an LDAP query for a defined search key.
This option is applicable only if you configure the 'Query
Type' parameter to LDAP.To configure LDAP Server
Groups, see Configuring LDAP Server Groups on page 240.

Dial Plan: Specifies a Dial Plan (name) in which to search
for a defined search key. This option is applicable only if
you configure the 'Query Type' parameter to Dial Plan. To
configure Dial Plans, see Configuring Dial Plans on page on
page 549.
To configure the search key, use the 'Search Key' parameter
(see below).
Defines the key to query. For LDAP queries, the key string is
queried in the specified LDAP server. For Dial Plan queries,
the key string is searched for in the specified Dial Plan. For
ENUM queries, the key string is queried in the ENUM server.
The valid value is a string of up to 100 characters. Combined
strings and values can be configured like in the Message
Manipulations table, using the '+' operator. Single quotes (')
can be used for specifying a constant string (e.g., '12345').
Examples:
Description
389
18. SIP Definitions
Mediant 4000 SBC