a.
b.
•
If a device reset is required:
a.
b.
Warning:
memory and thus, revert to their previous settings if the device later undergoes a
hardware reset, a software reset (without saving to flash) or powers down. Therefore,
make sure that you save your configuration to the device's flash memory.
6.1.6
Configuring Table Parameters
A typical configuration table is shown below and subsequently described:
Table 6-2: General Description of Configuration Tables
Item #
Button
User's Manual
On the toolbar, click Save; a confirmation message box appears:
Figure 6-4: Save Configuration Confirmation Box
Click Yes to confirm; the changes are save to flash memory.
On the toolbar, click Reset; the Maintenance Actions page opens.
Click Reset; the device saves the changes to flash memory and then resets.
When you click Apply, your changes are saved only to the device's volatile
Figure 6-5: Description of Tables
52
Mediant 4000 SBC
Document #: LTRT-40203