AudioCodes Mediant 4000 SBC User Manual page 124

3. Configure the port according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Table 11-2: Physical Ports Table Parameter Descriptions
Parameter
General
Index
Name
port
[PhysicalPortsTable_Port]
Description
port-description
[PhysicalPortsTable_PortDescription]
Mode
mode
[PhysicalPortsTable_Mode]
Speed and Duplex
speed-duplex
[PhysicalPortsTable_SpeedDuplex]
Ethernet Group
Member of Ethernet Group
group-member
[PhysicalPortsTable_GroupMember]
Group Status
group-status
[PhysicalPortsTable_GroupStatus]
User's Manual
(Read-only) Displays the index number for the table row.
(Read-only) Displays the Ethernet port number. See the figure
in the beginning of this section for the mapping between the
GUI port number and the physical port on the chassis.
Defines a description of the port.
By default, the value is "User Port #<row index>".
Note: Each row must be configured with a unique name.
(Read-only) Displays the mode of the port.

[0] Disable

[1] Enable (default)
Defines the speed and duplex mode of the port.

[0] 10BaseT Half Duplex

[1] 10BaseT Full Duplex

[2] 100BaseT Half Duplex

[3] 100BaseT Full Duplex

[4] Auto Negotiation (default)

[6] 1000BaseT Half Duplex

[7] 1000BaseT Full Duplex
(Read-only) Displays the Ethernet Group to which the port
belongs.
To assign the port to a different Ethernet Group, see
''Configuring Ethernet Port Groups'' on page 125.
(Read-only) Displays the status of the port:

"Active": Active port. When the Ethernet Group includes
two ports and their transmit/receive mode is configured to
2RX 1TX or 2RX 2TX, both ports show "Active".

"Redundant": Standby (redundant) port.
124
Mediant 4000 SBC
Description
Document #: LTRT-40203